Help

[damen.rudi]

Customer has 80 locks without keys. Brought in one to search the blank. The number on the lock is 7387. Tried already with a MLM1 and a HW4R but they didn't fit in the lock. Any idea? I have to make them on code because the rest of the lockers are still closed.

[grahamparker]

Do not recognise the lock but we have found that quite often MLM1 will not fit into a plug until it is cut.

[damen.rudi]

Have cut the MLM1 with Unocode but doesn't fit in.

[abababa]

22 minutes ago, damen.rudi said:

Have cut the MLM1 with Unocode but doesn't fit in.

What other blanks have you tried that fit in? The futura mentions LF2 and LF27 ( i know usually for garages) that have code series like yours

[Count Muppet]

Did you try LAS TK or LAS KT ? (Jma reference)

[keySolutions]

This is a JuNie lock.

I use HN3 for this. They can't be cut to code, but it's east to take the core out

[Growster]

The way the code is stamped on both sides of the key hole does point to Hekna, HN3 sounds like one to try.

[HowardK]

The lock appears to have a stepped wafer(s) indicating master keyed,  or key removable plug,  and or both,

indicating the use of right & left blanks if I am seeing the photo correctly

unless the top brass looking stepped part is a shoulder stop and not a wafer,

and I could just as well be barking up the wrong tree

[damen.rudi]

Silca HN3 fits perfectly. Found the lock also in the Junie catalogue. As already written, these keys can't be made on code by us. I'm going to give the importfirm a ring to see what can be done. Otherwise there is always the possibility to exchange the cores. Thanks for your help.

[keySolutions]

I sent you a PM yesterday with a possible solution.