Platinum question

[mrkeys]

Can someone explain what is happening or what I am doing wrong? If anything?

I've cut this key by decode on the Ninja

Why does it appear to look nothing like the original but still work perfectly?

I used the 13 pin Platinum, and I calibrated the jaws before hand

Track was entered by sight and the pins were decoded by the machine

I cant for the life of my figure out why it doesn't hit all the dimple cuts and the track looks a little off but the key works fine

It wouldn't be a problem but customers are quick to pick up on it and I find myself wasting time trying to explain that it will work before they have even left the shop?

I've cut 6 of them now all look off but all do work?

Thanks in advance

[grahamparker]

It is the way the machine is programmed to cut. Have similar issue with a Triax pro, on the snake cut the machine returns to position 1 after every cut.

So rather than a smooth straight line when you have 2 x 3 cuts side by side on the original the machine will cut a 3 go to a 1 then down to a 3 cut and so on.

If they keys work don't worry about it.

[lockdecoders]

looks like it is not cutting deep enough. Also check the track numbers as it doesnt look right at the tip.

[grahamparker]

13 hours ago, lockdecoders said:

looks like it is not cutting deep enough. Also check the track numbers as it doesnt look right at the tip.

Why does it appear to look nothing like the original but still work perfectly?

If it works there is nothing wrong with the depths !!.

[lockdecoders]

Yes i see that now. Shows how bad they are