Hafele master key help hf75r profile

[abababa]

Hi  

I'm not sure if a master key is possible for these locks. They are on the hf75r profile. I have cut all 3 that instacode recommends but not luck. The locks begin with "3" so I think it should be the mk3? Cuts 113311 . They are all going in but not turning any locks. Is this most likely that these do not support a master key or is there any other suggestions? Thanks

 

[HowardK]

cutting them on opposite key profile ?

I think you folks have something similar in the UK to this site, might be helpful or not

https://easykeys.com/Hafele

if you remove the screws (and or file the stakings if needed), can you remove and then depress retainer wafer, remove plug and insert keys you cut to determine where the problem(s) is

[Ewanda]

przyznaj klucz HF75 (Silca)

[grahamparker]

SKS used to sell the mk1,2,3 precut at a very good price.

I have lots of Genuine Hafele MK3 (30+) if you need some.

[abababa]

39 minutes ago, grahamparker said:

SKS used to sell the mk1,2,3 precut at a very good price.

I have lots of Genuine Hafele MK3 (30+) if you need some.

Thanks Graham.  The mk3 cuts are on the hf75 profile 113311 (This profile is the reverse of these locks)  HF75r works when duplicating the keys in the original photo (and also cutting to code).  But when i put the cuts onto a blank for the mk1 mk2 and mk3, they do not act as a master.

[grahamparker]

Do you want me to post you 1 genuine MK3 to test ?

[grahamparker]

We tried duplicating and they DID NOT WORK on HF75 blank but genuines Hafele keys did. Blank will not enter the lock.

[grahamparker]

Just found a Hafele Symo insert and the HF75 profile will not fit genuine Hafele master key does though.

[abababa]

1 hour ago, grahamparker said:

Do you want me to post you 1 genuine MK3 to test ?

Yea that would be great.  You have done wxm keys for me before.  Its the same address.  Let me know how much and i can paypal you or bacs