hakeemz Posted June 11, 2015 Report Share Posted June 11, 2015 looking for tapered back grub screw that holds lancer plus side cutter (flat) in place..birch, sks and nwkeys dont stock it.. its the allen screw that goes through the cutter into the rotating shaft just wondering what happens in cases like mine where its worn..am i suppose to dump the machine just because of this? any ideas? Link to comment Share on other sites More sharing options...
derek Posted June 11, 2015 Report Share Posted June 11, 2015 keyprint in edinburgh? Link to comment Share on other sites More sharing options...
inscriptio Posted June 11, 2015 Report Share Posted June 11, 2015 On my Lancer (not +) I use the Top hat type that replaces the blade and the sticky out bit (rotating shaft) SKS no: RST: TOC400W. I am better than 99% certain I used to use the same on my old lancer + but check anyway if I am right you will never go back to the flat type Link to comment Share on other sites More sharing options...
hakeemz Posted June 11, 2015 Author Report Share Posted June 11, 2015 is it possible to use top hat cutter on lancer plus? Link to comment Share on other sites More sharing options...
Matt@Silca Posted June 11, 2015 Report Share Posted June 11, 2015 Please contact Me (Matt) at Silca on 01293 531134. keithm 1 Link to comment Share on other sites More sharing options...
hakeemz Posted June 11, 2015 Author Report Share Posted June 11, 2015 fantastic, matt from silca to the rescue,,thanks very much silca.. keithm 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now