Paul_ Posted July 26, 2017 Report Share Posted July 26, 2017 Good morning, I have just installed a new compressor onto my glass engraving box. I have set the PSI to 20 and it is simply blowing the stencils off, my question is what PSI is yours set at? My machine is out in a back room so for me to play around with different settings would mean staying around after 5pm, I will just play about until it is right if needs be but surely someone must be able to save me some time. Cheers Paul Link to comment Share on other sites More sharing options...
beware Posted July 27, 2017 Report Share Posted July 27, 2017 Less than 6 bar. Link to comment Share on other sites More sharing options...
Mick Friend Posted July 27, 2017 Report Share Posted July 27, 2017 6 bar is 90psi ? = Bar = 15psi Link to comment Share on other sites More sharing options...
beware Posted July 27, 2017 Report Share Posted July 27, 2017 My Bad. Morning without coffee. We use the same compressor for our industrial dot markers as for temporary air assist. 6 psi is recommended for the dot markers. Last time that was too high when used on an LS900. Probably around 3-4 psi should be fine. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now