Dimple key I'd?

[cobblers.keys]

I'm wondering if there is an original blank for this key anywhere? I have been using the HD hply1 although it is slightly shorter. I need to order some today if possible. 

Thanks again 

[cobblers.keys]

Bump

[grahamparker]

WJ1R

[cobblers.keys]

Thanks, 

I have ordered these from aldridge however they are over 3 times more expensive than the HD version. 

[abababa]

8 hours ago, grahamparker said:

WJ1R

I'm 99 percent sure i saw these during the week..  They were fitted newly on a commercial property on 4 doors.  The guy just wanted key caps to differentiate the keys but I measured it up out of curiosity and WJ1r was about .75cm shorter.  Looked exactly the same profile though.  

[grahamparker]

These keys line up at the tip they are usually fitted to steel doors bought online. We cut on the Triax Pro checking the depth measurements then use the exact copy function. After that we run them through on the Mustang. Cut approx 20 so far this year and only had 1 back that needed a little more removing.

[cobblers.keys]

HD Hply1 are working fine so far I have cut 4 this week for a couple of units in a small shopping centre across the road from my shop. As you say they all have the same metal doors on. Cut on the mustang no problems so far. 

Thanks again