Jump to content

Kubota transponder key shell

Recommended Posts

  • 1 month later...
  • 6 months later...
On 11/10/2020 at 1:34 PM, Azaloid said:

I have a customer who has been using JMA YAMA 26D.P2 for these machine then cutting them down, he has done about 100 of these no problem.

Do you think that would be a case of cutting down and t hen cutting back the shoulders as otherwise the transponder would be a long way back from the antenna coil?

Link to comment
Share on other sites

7 hours ago, Azaloid said:

No as you are cutting from the shoulder head is still in the same position.

Not on the yama-26d.p blanks I have.  The distance between the Head and the shoulder is a lot greater than the JCB key.  That is why I thought maybe you would shorten the bit of the key then cut the shoulders back.



Link to comment
Share on other sites

  • 2 weeks later...
On 11/12/2020 at 7:38 PM, Lock Stock said:

Didn’t like look YH35R to thin between the flutes.
Used MAZ24R looked better suited to me, but did need to cut down the neck width when cutting key but worked fine. Chip wise was a 4D-60 chip if anyone else needs to know.

MAZ24R works fine

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...