Bronze Engraving Material

[CotswoldEngraver]

Hi all.

I am looking for a piece of bronze material to engrave a plaque for a customer but only need a small piece so don't want to go and purchase a full sheet.

Does anyone have any offcuts lying around. I need 1 piece 4" x 3.5".

PM me with cost and I will also make donation to the forum's charity. 

[Simes]

27 minutes ago, CotswoldEngraver said:

Hi all.

I am looking for a piece of bronze material to engrave a plaque for a customer but only need a small piece so don't want to go and purchase a full sheet.

Does anyone have any offcuts lying around. I need 1 piece 4" x 3.5".

PM me with cost and I will also make donation to the forum's charity. 

Umarq will cut you a piece of Bronze coloured Jewellers Brass I think.  I don't have any scraps that size.

[handlebarsandy]

Hi Cotswold engraver,

I have plenty of milled bronze offcuts.

Email me: info@brightonengravers.com to remind me and to get my address.  I will cut to size & weigh and tell you what postage to put on a padded pre-paid SAE

You'll just be paying for the postage.

Hope this helps.

Handlebars Andy

[kobblers]

Do you offer a trade engraving service, Andy?

Rick.

[CotswoldEngraver]

On 9/3/2019 at 10:50 PM, handlebarsandy said:

Hi Cotswold engraver,

I have plenty of milled bronze offcuts.

Email me: info@brightonengravers.com to remind me and to get my address.  I will cut to size & weigh and tell you what postage to put on a padded pre-paid SAE

You'll just be paying for the postage.

Hope this helps.

Handlebars Andy

Thanks Andy.

The customer eventually changed their mind and went for brass! All sorted now thanks.

Regards Andy