kobblers Posted February 25, 2016 Report Share Posted February 25, 2016 Does anyone recognise this key? It's a gauge 5½, 10cm from end to end and has no collar. I'd try to cut it from a gauge or pin key but the bits aren't thick enough to accommodate the bullet groove - I think the bit may have been slightly wedge shaped at some point, although it's difficult to tell. Apparently, the lock's over a hundred years old. Ta, Rick. Quote Link to comment Share on other sites More sharing options...
mathews Posted February 25, 2016 Report Share Posted February 25, 2016 Weld it? Quote Link to comment Share on other sites More sharing options...
x minit uk Posted February 25, 2016 Report Share Posted February 25, 2016 Cut it without the bullet groove, it may just fit without it . Ask the customer to try it and see. Quote Link to comment Share on other sites More sharing options...
Lee Posted February 25, 2016 Report Share Posted February 25, 2016 I could probably weld that together id you wanted Rick kobblers 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.