wanted broken hurricane laser key cutting machine

[roger]

Hi all I haven't posted for a while and I'm hoping someone can help me?

as the title says I'm after a broken hurricane laser key cutting machine for spares as I'm after the shaft that holds the cutter, also is there any way of calibrating them as it seems to cut to far? any help would be much appreciated.

 

kind regards

Roger

[Bobs Locks]

You need to have to blank keys in the jaws then have the shaft finger tight on the bit. bring the cutter down till is touching  then tighten.  your looking to get a half moon kind of ring on the key when your present it to the key any more and your to deep any less and not deep enough. hope tyhat helps 

[roger]

thank you for your reply, I will give that a go, I cut a key the other day and it looked as though it cut too much off the right side, I do have the same size cutter and tracer. thank you again.