Start Up Help

[cardi locks]

Hi all, need advice on engraving, currently no experience at all,we did visit show recently and looked at all the new machines.

We would like to offer engraving as part of our service, just think initial outlay of approx 10 grand a bit much at present, can anyone recommend poss second hand machinery to start off, we will be wanting to cover all bases,(cylindrical and flat).

Thanks in advance steve.

[key cabin]

Hi Steve,

First and foremost you need to learn to walk before you can run, investigate the type of engraving you will be doing,I.E. cylidrical, glass or will you just be doing flat based engraving (trophy plates and the likes)

If you need advise and some training you wont go far wrong in calling Mark at U-Marq, he will give you all the advise you need in starting up. 07748645636

There is plenty of advise and tuitions on this forum, have a look in the Tutorials section.

 

Good Luck and welcome

 

 

Dave