mila key

[earlsdoncobbler]

hi can anyone i d this key please i have tried to cut it on a un 1 the customer told me it would not enter the lock

on the front it has Mila hardware and on the rear bs en 13032005 grade 6 16000c60

thanks in advance

[Mark A]

The key is from a Mila Pro-Linear cylinder, suggest you contact mila direct for info on availability of blanks.

www.mila.co.uk

 

Mark

[Auto Key Wizard]

MIL1 or N9CS would be my choices to try

[k4mrc]

my thought is -

KBT1R

[earlsdoncobbler]

it worked out that the un1 did go in but did not turn wish people told you correct worked out the office was only around the corner from me so poped around to have a look n9cs and 1a fitted and worked the 1a worked after filling the shoulder back a little as the mila key is longer went with the 1a as did fit better after the shoulder filed back

[k4mrc]

i have had the same blank in my shop, it is the KBT1R hook number xgc005 dav burgss.

[toofatbyfar]

kbtr1

[tommy]

I have cut a few of these and found that the 5 pin universal is long enough to cut the levers but not long enough to work the lock but the 6 pin uni, although you will grind alot off the end, will work.

Tommy

[Technical Tony original]

Would anyone have tried a JMA MI-4D - to see if it works at all ?

 

Thank you John

[toofatbyfar]

yep, it does work, we use MI-4D all the time now, without any comebacks,, \:D/

[Guest Cjm]

The KBTR1 has now been discontinued. The IE6 ISEO blank will suit, our stock reference H0165.

[toofatbyfar]

i think you will find the ISEO key a little short, MI-4D, is spot on