doug Posted November 27, 2021 Report Share Posted November 27, 2021 When I bring up a pattern with Z set to "0" it always helps to choose the correct cutter tool. The problem is as I set that tool to go deeper say .010 it shows the pattern almost gone, it seems to me that going deeper would just make a blob, not disappear! If I use Gravoply, set the depth of the spindle to just more than the total thickness of it, adjust the dial to cut at .010 it comes out fine. It seems backwards to me Quote Link to comment Share on other sites More sharing options...
beware Posted November 30, 2021 Report Share Posted November 30, 2021 I don't use it. I prefer to use the machining window preview. At a guess, it's recalculating your fill and deciding it can't engrave. doug 1 Quote Link to comment Share on other sites More sharing options...
doug Posted December 1, 2021 Author Report Share Posted December 1, 2021 Where is the machining window preview? Quote Link to comment Share on other sites More sharing options...
beware Posted December 1, 2021 Report Share Posted December 1, 2021 The button is marked Preview and is near to your Run button. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.