Yale z12b

[Ian platt]

Cut x3 of these manually off customers key worked from inside  but not  but not outside      Went over them but still the same  my colleague cut three new same thing   Any ideas    Graham if your reading sent an order for one but had no reply via email are you cutting these  ??

[grahamparker]

Yes mate, cut and just posted about 20 minutes ago. Did not see the email until first thing this morning.

[Ian platt]

Ok thanks Graham  

[Ian platt]

So ordered  it to code  and still had same result  works from inside and not out  ! That’s 7 keys 3 different machines and 3 different people cutting them   Hate these locks 

[abababa]

Gotta trace that manually...It's a buggar sometimes...   manufacturing deficiencies means slightly different pin depths from inside to outside the current key is bypassing somehow. if you cut to code, then it will not allow for these deficiencies on one side of the lock. You want to be a master of it, install them a new lock, get their old lock and test, diagnose.

[grahamparker]

It was traced manually on 6 of the keys and one was cut on my Triax. We have cut thousands of these and generally have no issues. It’s usually the angle cuts that just need to be cut less deeper than the original. If I ever have a key back twice then we credit the key against a new ABS master cylinder.