Jump to content

Recommended Posts

2 hours ago, Gray said:

Michael. Standard do them comes with a tool which is bloody expensive for what it is. Get your blade tell them you don't want the tool and I'll lend you the tool I have. 

 

Not to difficult to make one, flat piece of steel 6-8 inch long 2 holes drilled same distance apart as holes in blade at one end, drive in 2 pins same diameter of holes, job done.

If I remember correctly blade is reverse thread.

Link to comment
Share on other sites

On 6/3/2021 at 2:53 PM, Michael said:

I have this model but in much worse condition!!!

Any idea if I can get a replacement blade, and how do I remove the old one???

Yes blades are available and easy enough to remove without the tool. First you have to unscrew the bottom roller then get a screwdriver in one of the holes and a sharp tap with hammer loosens it enough to unscrew by hand (Note the blade is a left hand thread)

1320851978_Ranger2.thumb.jpg.8a6722462e9f3338294e349b2f69dae9.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...