Jump to content

Recommended Posts

I've just finished my occasional Bravo Pro set up ,where I get it as accurate as possible so I can cut a key then a copy , then a copy from a copy and so on until I get about 7 blanks in from each other and still turn a Euro cylinder ....

....am I Obsessive on settings or are there any other Saddos out there ? ...haha

Link to comment
Share on other sites

i do it that way too, i was using an old cea naty that i had stripped down, repainted , changed the cutter and set it up, was cutting better than the bosses silca rekord that is only 3 years old, let's face it, you don't always get a key in that's been cut from an accurate machine, so the more accurate yours is the better imo

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...