Growster Posted September 14, 2016 Report Share Posted September 14, 2016 I am just making A5 Evva open section keys to code on a Silca EV10. The keys will only work, if I cut them twice. There is no unusually deep cut. I am stumped by this. If this was a calibration issue, the machine would never get it right, would it? Quote Link to comment Share on other sites More sharing options...
grahamparker Posted September 14, 2016 Report Share Posted September 14, 2016 Ring and speak to Matt @ Silca. That's what i do when i get problems. Quote Link to comment Share on other sites More sharing options...
Lock Stock Posted September 15, 2016 Report Share Posted September 15, 2016 How old is your cutter? If your cartridge speed is set high/fast and using a blunt cutter, that would make sense. Also I'm also assuming your using silca EV10? They are steel keys which won't be either Quote Link to comment Share on other sites More sharing options...
Matt@Silca Posted September 15, 2016 Report Share Posted September 15, 2016 As mentioned above, the most likely cause is that your cutter has lost its edge and is unable to remove enough material at the current cutting speed. You may be able to slow down the cutting speed in the options and be able to cut the key in one pass for the time being, but you will likely need to replace your cutter soon anyway. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.