Jump to content

give this a go


Recommended Posts

I made these jigs for holding three medals at once on the IS200.

447_030308_0919_1.jpg447_030308_0920_1.jpg

I cut down trophy rods to 15mm, then screwed them into the 8mm perspex with a bit of araldite for good measure, then covered them with the white rubber tips you get on cutters. I have added an eps file to the downloads section for the jig and the engraving too. I can guarrantee this will speed up production on large medal runs :smt023

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...