Jump to content
Sign in to follow this  
kobblers

glass cutters

Recommended Posts

i finally found the solution to my glass engraving problems, mastergrave's cutters!!!!!!

i ordered and received one from kev and it works an absolute treat and at the speed i would expect!!!

now i can carry on glass engraving as i was seriously considering stopping it.

thanks kev :D :D :D :D

Share this post


Link to post
Share on other sites

I was recently struggling with my glass engraving - took a few runs over before it cut into the glass properly.

Bought a new cutter (from Mastergrave) - works fine first time.

Lesson learnt (again) don't be a skinflint with cutters, they DO wear out, and think about not how old a cutter is, but how much it's earnt you in the 3/6/9 months you've had it!

Share this post


Link to post
Share on other sites

For the record, the cutters I supply don't come from Mastergrave. They are simply sourced from the same place that Mastergrave buy theirs from.

 

Glad your cutters are OK now, Rick.

 

Kev

Share this post


Link to post
Share on other sites

lol kev, my post was badly put, my intention was to say that it was the cutters supplied by mastergrave that were causing me the problems, if you source yours from the same place then how unlucky am i to get two from them that were next to useless?

rick.

Share this post


Link to post
Share on other sites

sorry Rick - a bit of confusion reading your post! :?

 

Maybe Mastergrave don't buy their cutters from our supplier.

I have dealt with our our supplier for nearly 15 years now and have never had any complaints.

 

Glad to have helped you, let me know if you need anything else

Share this post


Link to post
Share on other sites
Guest Phill

Kev, i'm interested in your point about glass cutters. we use mastergraves composite rotating diamond and never had problems. But you know of a better one? I think we pay about £45 for ours. I could do with a glass cutter that performs cleanly at nearly full speed. Is there such a cutter? I have the mastergrave universal.

Share this post


Link to post
Share on other sites

Phil,

 

I supply a faceted diamond cutter, in many different sizes and prices, to suit nearly all manual and computerised engravers.

 

I will be glad to help contact signs@charlesbirch.com with your individual requirements.

 

Don't want to fall foul of Lee's advertising rules by discussing individual's needs on here :D

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×